KNOW YOUR TABLE SAW
See Figure 2.
Beforeattemptlng to use this product, familiarize yourself
with all operating features and safety rules.
ANTI-KICKBACK PAWLS - Kickback is a hazard inwhich
the workpiece is thrown back toward the operator.The
teeth on the anti-kickback pawls point away from the
workpiece, if the workpiece sbou[d be pulled back toward
the operator, the teeth dig into the wood to help prevent
or reduce the possibility of kickback.
BEVEL SCALE - The easy-to-read scale on the front of
the cabinet shows the exact blade angle.
BLADE - This saw is provided with a 36-tooth, 10 in.
carbide blade. The blade is raised and lowered with,
the height/bevel adjusting handwheeL Bevel angles are
locked with the bevel locking lever.
,_ WARNING: Do not use blades rated less than the
speed of this tool. Failure to heed this warning could
result in persona] iniury,
BLADE GUARD - Always keep the blade guard down
over the saw blade for through-sawing cuts.
BEVEL LOCKING LEVER - This lever, placed just under
the saw table surfaceon the front ofthe cabinet, locksthe
angle setting of the blade.
HEIGI-rF/BEVEL ADJUSTING HANDWHEEL - Located
on the front of the cabinet, usethis handwheel to lower
and raise the blade for height adjustments or blade re-
placement. This handwhesl also makes the adjustment for
bevel angles easy.
MITER GAUGE - The miter gauge aligns the wood for
a cross cut. The easy-to-read indicator shows the exact
angle for a miter cut, with positive stops at 90 ° and 45 _.
MITER GAUGE GROOVBS - The miter gauge rides in the
grooves on the saw table.
MOTOR - The powerful industion motor, with capacitor
start and V-belt drive, is housed in a sturdy steel base.
OUTFEED SUPPORT - This table extension at the back
of the tool gives the operator additional support when cut-
ting longworkpieces.
RIP FENCE - A sturdymetal fence guides the workpiees
and is securedwith the lockinghandle. Grooves runalong
the top and sides ofthe ripfence for use with optional
clamps and accessories,
SCALE - Located on the front rail, the easy-to-read scale
provides precise measurements for rip cuts,
SLIDING TABLE EXTENSIONS - Located on each side
of the saw table, these table extension gives the operator
additional support when cutting wide workpieoes.
SPREADER - A metal piece of the hie,de guard assembly,
slightly thinner than the saw blade, which helps keep the
kerr open and prevent kickback.
SWITCH ASSEMBLY - This saw has an easy access
power switch located below the front rail. To lock the
switch in the OFF position, remove the switch key from
the switch. Place the key in a location that isinaccessible
to children and others not qualified to use the tool.
11
To Next Page
Loading...
Need help?
General