A
A WARNING: When servicing, use only identical
replacement parts. Use of any other parts may create
a hazard or cause product damage.
WARNING: Always wear safety goggles or safety
glasses with side shields during power tool operation
or when blowing dust. If operation is dusty, also wear
a dust mask.
GENERAL
Avoid usingsolvents when cleaningplastic parts, Most
plastics are susceptible to damage from vadous types of
commercial solvents and may be damaged by their use.
Use clean clothsto remove dirt, dust, oil, grease, etc.
_I, WARNING: Do not at anytime let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc., come incontact with p[astic parts.
Chemicals can damage, weaken, or destroy plastic
which may result in seriouspersonal injury.
• Periodically check all clampS, nuts, bolts, screws, and
belts for tightness and condition. Make surethe throat
plate is in good condition and in position.
• Check the blade guard assembly.
• TOmaintain the table surfaces, fence, and rails,
periodically apply paste wax to them and buff to
provide smoothfunctioning. To prevent work from
slipping during cutting operation, Do not wax the
working face of the miter gauge.
• Protect the blade by cleaning out saw dustfrom
underneaththe table and inthe blade teeth. Use a
resin solventon the blade teeth.
• Clean plastic parts only with a soft damp cloth. Do
not use any aerosol or petroleumsolvents,
LUBRICATION
This saw has been lubricated at the rectory prior to ship-
ment.
36
To Next Page
Loading...
Need help?
General