UNPACKING
This product requires assembly.
= Carefully lift saw from the carton and place saw on the
aide with the wheels.
NOTE: This tool is heavy. To avoid back injury,keep
your knees bent and liftwith your legs. not your back,
and get help when needed.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping_
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After
assembling it,cheek for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
• If any pans are damaged or missing, please call
1-800-932-3188 for assistance.
_L WARNING" If any parts are missing, do not operate
this tool until the missing pans are replaced. Failure
to do so could result in possible serious personal
injury.
_, WARNING: DOnot attempt to modify this tool
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury,
_, WARNING: Do not connect to power suppry until
assembly iScompTete. Failure to comply could result
Jnaccidental starting and possible sedous personal
injury.
_IL WARNING: De not liftthe saw without help. Hold
it close to your body. Keep your knees bent and
lift with your legs, net your back. Ignoring these
precautions can result in back injury.
WARNING: Never stand directly in line with the
blade or allow hands to come closerthan 3 in. to the
brads. Do not reachever or across the blade. Failure
to heed this warningcan result in serious personal
injury.
_k WARNING: To avoid serious personal injury, always
make sure the table saw is securely mounted to
a workbench or an approved leg stand. NEVER
operate the saw en the floor.
TO ASSEMBLE THE SPIDER LEG STAND
See Figures 7- 8.
• Remove the spider leg stand from leg stand storage in
the back of the saw by separating the hook and loop
straps.
• Place the leg stand on the floor then open the leg
stand by pushing opposite legs in opposite directions
as indicated by the arrows in figure 7.
I
HOOK
ANDLOOP
STRAPS
Fig, 7
Fig. 8
15
To Next Page
Loading...
Need help?
General