]
Saw does not make aCCurate
90" or 45" Outs.
I
Height/bevel adjusting hand-
wheel is hard to turn.
Sew does not start.
Positive stops insidecabinet need
adjusting (Bevel Cuts).
Miter gauge is rnisaligned (Miter
Cuts).
Gears or screw post inside
cabinet ere clogged with saw
dust.
Motor cord or wall cord is not
plugged in,
Circuitfuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Adjust positive stops.
Adjustthe miter gauge,
HHn • n
Clean the gears or screw post.
• •nn
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breake[
Have the cord or switch replaced at your
Sears Service Center.
m
Blade makes poor cuts.
Blade is dull or dirty.
Blade is wrong type for cut being
made,
Clean, sharpen, or replace blade,
Replace with correct type.
Blade is mounted backwards.
Remount blade.
Blade does not lower when
turning height/bevel adjusting
handwheel.
Locking lever is not at full left
position.
Move locking Feverto left_
Motor labors in rip cut. Blade not proper for rip cut. Change blade; rip blade typically has fewer
teeth.
38
To Next Page
Loading...
Need help?
General