15
CraftBot 3
5. When the rst head has moved to the reference point which will be at the front screw point, the build
platform and the nozzle tip must be set perfectly to each other with the nozzle JUST touching the
surface of the build platform. with no space between nozzle and bed.
6. Then, press the change heads button in the middle.
7. The First head will move back to the home position and the second head will move to the same
reference point at the front of the build platform.
8. loosen the two screws on the left side of the Black heatsink. Drop the nozzle to the bed and tighten
the screws.
9. Repeat this twice to make sure that both heads 1 and 2 are at the correct same Z height position.
If you have moved the build plate leveling screws please go back to redo a bed leveling.
To Next Page
Loading...
