CraftUnique CraftBot 3 - Important Information and Safety

4
CraftBot 3
1.1. IMPORTANT
Read this user manual carefully before you use the appliance, and save it for future reference.
All information in this user manual is subject to change at any time without notice and is provided for
convenience purposes only. CraftUnique reserves the right to modify or revise this user manual in
its sole discretion and at any time. By using the manual, you agree to be bound by any modications
and/or revisions. For up-to-date information contact the CraftUnique Service Support
(support@craftunique.com).
1.2. WARNINGS
• Check if the voltage indicated on the sticker at the back of the appliance that it corresponds
to the local mains voltage before you connect the appliance.
• Do not immerse the power cord, plug or any other parts into water or any other liquid. This
may cause electrical shock.
• Do not use the appliance if the plug / mains cord or the appliance itself is damaged or not
operating properly.
• If the mains cord is damaged, you must have it replaced in order to avoid hazard.
• Only connect the appliance to grounded wall sockets.
• Keep the mains cord away from hot surfaces.
• Do not let the mains cord hang over the edge of the table or worktop on which the appliance stands.
• Keep the appliance and its cord out of the reach of children.
• This appliance can be used by children from the ages of 8 years and above; and by persons
with reduced physical, sensory or mental capabilities or lack of experience and knowledge. Only
under supervision and adequate instruction concerning the use of the appliance in a safe way,
understanding the hazards involved. Cleaning and user maintenance shall not be made by children.
• Children can receive great educational benets from designing 3D objects. But the printing process
should not be done by small unsupervised children.
• Do not touch moving parts or heated elements, it can cause injuries.
• Never reach inside the machine when turned on. Dierent parts of the machine (mainly the extruder
and heated build plate) operate at very high temperatures and can cause severe burns.
• Never leave the CraftBot 3D printer unattended while it is plugged in and is in operation.
• Make sure that the power supply is o and that the power cord is disconnected before servicing. Allow
at least 5 minutes for the device to cool down after unplugging it before reaching inside to service.
• Always turn o the printer and disconnect from the computer when it is not being used.
1.3. CAUTION!
• Make sure to level the build plate properly before use.
• Make sure not to force anything, whether it be during unpacking, setup, operation or service.
• Service and oil the suggested parts as often as recommended. Use only substances recommended
by CraftUnique. (Normally after every 50 printing ours)
• The CraftBot 3D printer melts plastic during printing. Plastic odors are emitted during this operation.
Make sure to set up the CraftBot 3D printer in a well-ventilated area.