Contents [ hide
1 Content
2 NOTES
3 Product introduction
4 Equipment parameters
4.1 Basic Parameters
5 Spare parts
6 1. Installation of Z-axis limit switch kit and Z-axis profiles
7 2. Install Z-axis motor kit and t-type screw
8 3. Install pneumatic joint, XE-axis kit and synchronous belt
9 4. Install extrusion kit, Z-axis passive block
10 5. Install X-axis Tensioner
11 6. Install Z-axis moving kit
12 7. Install the gantry profile,display kit
13 8. Install material rack, gantry cover and indication knob
14 9. Wire connection
15 10. Preheat
15.1 Method 1
15.2 Method 2
16 11. Load the filament
17 12. Start printing
17.1 Print
18 Wiring connection
19 Troubleshooting
20 Read More About This Manual & Download PDF:
21 Related Manuals:
Content
Dear Consumers,
Thank you for choosing our products. For the best experience, please read the instructions before
operating the Printer. Our teams will always be ready to render you the best services. Please contact
us by phone number or e-mail address provided at the end when you encounter any problem with the
Printer.
For a better experience in using our product, you can also learn how to use the Printer in the following
ways:
View the accompanied instructions and videos in the TF Card.
Visit our official website www.creality.com to find relevant software/hardware information, contact
To Next Page
Loading...
Need help?
General
