Note: Replace the filament:
1. If no filament in the nozzle, cut the filament at the extrude, put the new filament into the tube,
and until the filament arrives on the feeding tube.
2. If filament in the nozzle, heat up the nozzle to 185°+, draw out the filament, and then replace the
filament according to step 1.
3. If replace the filament during the printing process.adjust the printing speed to 10%, and then
replace the filament according to step 2.
12. Start printing
Please level the platform according to the video in storage card. Bad leveling will cause clogging or
To Next Page
Loading...
