Crestron DGE-100 Supplemental Guide

40 • DGE-100/DM-DGE-200-C: Digital Graphics Engines Supplemental Guide – DOC. 7696C
Control System
Click Control System to configure a connection to a Crestron control system.
Device Page - Control System
• Encrypt Connection: Toggle the switch to turn on or off an encrypted connection
to the control system.
• Control System Username: If Encrypt Connection is enabled, enter a username
for the encrypted connection.
• Control System Password: If Encrypt Connection is enabled, enter a password
for the encrypted connection.
• Confirm Password: Reenter the password set for Control System Password.
• Room ID: Enter a control system room ID to associate with the DGE (for
connections with the Crestron Virtual Control server-based control system)
NOTE: For more information on connecting the DGE to Crestron Virtual Control,
refer to the help file in the Crestron Virtual Control web configuration interface.
To access the help file, click the question mark button on the top left of the
page.
• IP ID: Enter an IP ID for connecting the DGE to the control system.
• IP Address/Hostname: Enter the control system IP address or hostname.
• Status: Reports the status of the control system (ONLINE or OFFLINE)
Click Save Changes next to the Control System tab to save any changes. Click Revert to
revert to the last saved settings.

Crestron DGE-100 Specifications

General

Brand	Crestron
Model	DGE-100
Category	Engine
Language	English