Crestron DM-NVX-D30 - DSCP (Differentiated Services Code Point)

Product Manual – DOC. 8425B DM-NVX-E30(C)/DM-NVX-D30(C)/DM-NVX-D80-IOAV
•
13
DSCP (Differentiated Services Code Point)
NOTE: DSCP configuration is applicable to the DM-NVX-E30 and DM-NVX-E30C only.
To implement Quality of Service (QoS), IP networks use the DSCP value. Within an
IP packet header, the DSCP defines a value from 0 to 63 that maps to a certain traffic
classification. Based on IT department policies, DSCP values are used within a network
to determine the treatment of packets in router queues, the routes of traffic flows, and
per-hop behavior. By default, DSCP is set to 32.
NOTE: Change the DSCP default setting of 32 only if required by IT department policies.
Configure DSCP on the Stream page. In the Advanced section of the page, set a
DSCP value:
1. Set Auto Initiation to Disabled.
2. Stop the stream by clicking Stop.
3. Select the Custom DSCP checkbox.
4. Enter the desired DSCP value (0 to 63).
5. Set Auto Initiation to Enabled. The stream automatically restarts.
NOTE: Deselecting the DSCP checkbox returns the DSCP value to the default setting.
Stream Page - DSCP Configuration