Crestron IV-CAMHK-12-SLVR-1B - Onscreen (OSD) Menu

Product Manual — Doc. 9311C IV-CAMHK-12-SLVR-1B • 58
2. Select Open Media > Network (tab) and enter the RTSP URL using the following syntax:
rtsp://xx.xx.xx.xx:554/4.h264
Substitute “sub” for the secondary stream from the wide-angle camera or “3” / “4” for subsequent
streams.
To monitor the camera’s other streams type in the following strings after the “/”:
l
main.h264 - Left PTZ
l
sub.h264 - Wide-Angle
l
3.h264 - Right PTZ
l
4.h264 - Switched Output
To learn how to adjust the bit rate and resolution settings for the camera’s RTSP streams, refer to the
1BeyondCameraManager manual.
NOTE: The VLC player induces noticeable latency when monitoring RTSP streams.
Onscreen (OSD) Menu
<MENU>
VIDEO...
EXPOSURE...
COLOR...
PAN TILT ZOOM...
SYSTEM...
STATUS...
RESTORE DEFAULTS...
[▲▼] SELECT [OK][ ] NEXT
All 1Beyond cameras feature an integrated on-screen menu which can be accessed by pressing Menu in
the PTZ controller section of 1BeyondCameraManager or on the IRremote control. The menu is then
displayed overlaid on the camera’s PTZ video feed.
Here you can adjust various settings to tailor the camera’s performance to the setup.
Navigate the menu using the directional buttons in the software. In the software, press Enter to confirm
a menu selection, and use the left and right directional buttons to adjust the selected parameter.