EasyManua.ls Logo

CS-Lab CSMIO/IP-M

CS-Lab CSMIO/IP-M
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.8 Recommended cables
Connections type
Recommended cable
Digital In/out
Minimum cross-section 0,25mm
2
Analog In/out
Cross-section 0,25mm
2
(Shielded or twisted pair
recommended)
Drives controlling (STEP/DIR)
Cross-section 0,25mm
2
; shieldedtwisted. You can possibly
use the FTP computer cable.
Please note that for signals
(STEP + / STEP-) (Dir+ / Dir-
) you should always use twisted
pair cables.
Ethernet Communication wire
Standard Ethernet cable, shielded - FTP, cat. 6. See 4.7
Power
Min. Cross-section 0,5mm
2
CAN expansion modules
If modules are mounted on the same DIN rail next to the
controller you can use DB9 plugs clenched on the 9-wire tape
(if further – use shielded twisted pair).
During mechanical and electrical mounting particular caution is advised. Poorly tightened cable
may cause many trouble; it’s also very difficult to find such a defect while launching/using the
system.
CS- Lab s.c. CNC CSMIO/IP- M controller
Page 16

Table of Contents

Related product manuals