CS-Lab CSMIO/IP-M User Manual

• In this window – select the „Internet protocol (TCP/IP)” position and click left mouse button
on the „Properties”.
• In this window enter the IP address: 10.1.1.1 and a mask: 255.255.255.0. Click “OK”.
• Close the window.
• The network is now set to work with CSMIO/IP-M.
At power “On” the CSMIO/IP-M controller automatically sets the IP address (it sends request to the DHCP
sever). After three failed attempts, without response from the server- the default IP address is set:
10.1.1.2. It does not last longer than 10 sec. but you should remember to wait 10 sec. after switching the
power on, to let the controller communicate with the device.
Remember to use shielded cables. Ethernet connections are highly resistant to interference but shielded
cable should be used, especially if you use serves or spindles with large power.
CS- Lab s.c. – CNC CSMIO/IP- M controller
Page 27

CS-Lab CSMIO/IP-M Specifications

General

Brand	CS-Lab
Model	CSMIO/IP-M
Category	Controller
Language	English