CS-Lab CSMIO/IP-M User Manual

After this operation, we can start the work from the second file not forgetting about the measurement
after tool change („Auto Tool Zero” button).
When the file is loaded, and the tool is measured we can set the axes again over the material with the MDI
like before.
Press „Cycle Start” and start the process.
Photos below show the work piece during the process, after work and after removal from the machine
– after gentle sanding with emery paper.
CS- Lab s.c. – CNC CSMIO/IP- M controller
Page 62

CS-Lab CSMIO/IP-M Specifications

General

Brand	CS-Lab
Model	CSMIO/IP-M
Category	Controller
Language	English