Cub Cadet 900 series Professional Shop Manual

MAINTENANCE INTERVALS
150
Fuel filter
A dirty fuel filter can result in a lean run condition. The
fuel filter should be replaced every 100 hours.
To replace the fuel filter:
1. Clamp off the fuel lines to prevent fuel from leak-
ing when the lines are disconnected.
See Figure 9.4.
IMPORTANT: Take care that the fuel lines are
not damage when clamping them off. Never
insert a screw or anything else into the fuel line
to prevent fuel from coming out. This will dam-
age the inside of the fuel line.
NOTE: There are commercially available fuel
line clamping tools that will not damage the fuel
lines.
2. Squeeze the tabs on the fuel line clamps and
slide them away from the filter.
3. Carefully slide the fuel lines off of the filter. If
there are pieces of rubber on the barbs of the
fuel filter, replace the affected fuel line.
IMPORTANT: The 900 series tractor uses low
permeation fuel line to meet EPA guidelines.
When replacing the fuel lines, they must be
replaced with the same type of low permeation
fuel line.
4. Install the new filter by following the above steps
in reverse order.
5. Test run the engine and check for leaks before
returning to service.
Clean the engine
Air cooled engines cool better if they are clean. Check
for nesting or signs of nesting especially after dormant
season storage.
Lubricate the pedal shaft
NOTE: The deck does not need to be removed
to preform this procedure.
1. Remove the screw that secures the pedal shaft
support strap using a 1/2” wrench.
See Figure 9.5.
2. Gently pull down on the pedal shaft.
3. Apply a generous amount of a high quality lith-
ium grease to the support strap and the shaft
using a brush.
4. Put the support strap back in place and install
the screw that was removed in step 1.
5. Repeat steps 1 through 4 on the opposite side.
Figure 9.5
pedal shaft support strap
support strap

Cub Cadet 900 series Specifications

General

Brand	Cub Cadet
Model	900 series
Category	Tractor
Language	English