Cub Cadet RZT-S Zero - Deck Leveling Procedures

Body
19
NOTE: If the front main seat box assembly is being
replaced:
• Cut off the speed nuts that attach the seat bracket
studs to the front main seat box assembly.
See Figure 2.33.
• Slide the stud assembly out of the front main seat
box assembly.
• Install the stud assembly in the new front main
seat box assembly.
21. Install the front main seat box assembly by following
the previous steps in reverse order.
22. Test run the mower in a safe area before returning it
to service.
Figure 2.33
Speed nuts