RZT-S
38
Hydro neutral control adjustment
NOTE: Neutral control rarely goes out of adjustment on its own. If it needs adjustment, check for damaged
linkage or signs of tampering.
To perform the hydro neutral control adjustment:
NOTE: Perform the wheel alignment and drive con-
trol link adjustments before performing a
hydro neutral control adjustment.
1. Lift and safely support the rear of the mower.
2. Bypass the seat safety switch.
2a. Slide the seat to the full forward position.
2b. Flip the seat up.
2c. Remove the seat switch.
NOTE: The seat switch connector is a shorted NC
connector. That means when the connector
is unplugged, a tiny jumper inside the con-
nector shorts out the contacts. When the
connector is shorted, the circuit behaves as
if the seat were empty.
2d. Compress the switch plunger with a spring
clamp. See Figure 4.32.
! CAUTION! CAUTION
The mower engine and drive system must be operated to complete this procedure. Confirm
that no hazards will be incurred by running the engine or operating the drive system.
• Work in a well vented area to prevent carbon monoxide poisoning or asphyxiation.
• Be careful to avoid contact with hot parts or moving parts.
Figure 4.32
Seat safety switch
Figure 4.33
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
