14-18
14. PERIODIC SERVICE
Sc2450 Operator’s Manual
■ Check the Light Bulbs
1. Inspect the lights for blown bulbs and damaged
lenses.
2. Replace a broken bulb or lens.
■ Check the Tie-rod Rubber Boots
Check the tie-rod rubber boots for any break.
If any break is found, contact your local Cub Cadet
Yanmar dealer for technical assistance.
(A) Tie-rod rubber boots
■ Check and Clean the Electrical System
To avoid personal injury:
●Always replace damaged wires or connections
immediately and tighten any loose terminal or
connector. Loose or damaged wires, terminals
or connectors can influence the performance of
or cause damage to electrical components,
result in a dead battery or a short circuit, which,
consequently, can pose a fire hazard.
●Never use a fuse with a larger capacity than that
recommended and do not attempt to bypass the
fuse system. Doing so could result in personal
injury, damage to electrical components or even
pose a fire hazard.
●Carefully plug and unplug any wiring connection
that is protected by a waterproof plug and
ensure that they are sealed securely and
properly after assembly.
●Regularly clean around the battery, all electrical
wiring, the engine and the exhaust system
before attempting to start or operate the tractor.
Any accumulated dirt, fuel, grease or other
deposits in these areas poses a fire hazard.
Never allow high-pressure water to directly contact
the battery, wiring, terminals, connectors, electrical
components, or the instrumental panel. Doing so can
cause an electrical malfunction.
Regularly check the following points:
1. Wiring harness clamps: Replace if necessary.
2. Wiring insulation: Replace if cracked or otherwise
damaged.
3. Connectors and terminals: Tighten if loose, clean if
contaminated, and replace if damaged or discolored.
4. Instrument panel: Make sure all switches and
gauges are operating correctly.
Contact your local Cub Cadet Yanmar dealer in
regard to maintenance, diagnosis and repair.
P3014960
(A) (A)
! WARNING! WARNING
To Next Page
Loading...
