15-9
15. SERVICE THE ELECTRICAL SYSTEM
Sc2450 Operator's Manual
■ Replace the Tail Light Bulb
1. Park the tractor safely.
2. Stop the engine and remove the key from the
starter key switch.
3. Remove the two screws and lens from the
assembly.
4. Push down and rotate the bulb to remove it.
5. Push the new bulb into the socket and rotate to
lock it into position.
6. Check that the tail light lights normally.
7. Reinstall the lens.
(A) Screw
(B) Lens
(C) Bulb
■ Replace the Turn Signal/Hazard Lights Bulb
NOTE
●The turn signal/hazard lights can be serviced after
removing the front or rear lens assembly.
1. Park the tractor safely.
2. Stop the engine and remove the key from the
starter key switch.
3. Remove the lens from the light assembly.
4. Push down and rotate the bulb to remove it.
5. Push the new bulb into the socket and rotate to
lock it into position.
6. Check that the turn signal/hazard lights operate
normally.
7. Install the lens.
(A) Lens
(B) Bulb
P3014936
(A)
P3014953
(C)(B)
P3014937
(A)
P3014954
(B)
To Next Page
Loading...
