Cub Cadet SC2450 - ROPS Lowering and Raising Procedures

8-4
8. OPERATION
Sc2450 Operator's Manual
3. Lower (fold) the Roll-Over Protective Structure
(ROPS).
To avoid personal injury:
●Always use both hands to hold the Roll-Over
Protective Structure (ROPS) securely and fold
the Roll-Over Protective Structure (ROPS)
slowly and carefully.
4. There are folded Roll-Over Protective Structure
(ROPS) retaining holes on both sides of the
lowered Roll-Over Protective Structure (ROPS).
Install the insert pins into these holes.
5. There are holes on both ends of the insert pin.
Install the hairpin clip into these holes.
NOTE
●To secure the play-absorbing vibration-insulating
rubber block, pull the upper bolt to the near side
and insert the pins.
(A) Roll-Over Protective Structure (ROPS)
(B) Hairpin clip
(C) Insert pin
■ Raise (Unfold) the Roll-Over Protective Structure (ROPS)
1. Pull out the hairpin clip from each of the insert
pins on both sides of the Roll-Over Protective
Structure (ROPS).
(A) Hairpin clip
(B) Insert pin
2. Pull out the insert pins from both sides of the Roll-
Over Protective Structure (ROPS).
3. Raise (unfold) the Roll-Over Protective Structure
(ROPS).
4. There are unfolded Roll-Over Protective Structure
(ROPS) retaining holes on both sides of the
raised Roll-Over Protective Structure (ROPS).
Install the insert pins into these holes.
5. There are insert pin jam holes on both ends of the
insert pin. Install the hairpin clip into these holes.
NOTE
●To secure the play-absorbing vibration-insulating
rubber block, pull the upper bolt to the near side
and insert the pins.
3016487
! WARNING
3016409
(A)
(B)
(C)
3016406
(A)
(B)