Cub Cadet SC2450 - Raise and Lower the Roll-Over Protective Structure (ROPS)

8-3
8. OPERATION
Sc2450 Operator's Manual
●ALWAYS operate the tractor with the Roll-Over
Protective Structure (ROPS) in the raised
(unfolded) position unless the tractor is being
operated in a low clearance situation.
Keep the retractable seat belt fastened while
operating the tractor with the Roll-Over Protective
Structure (ROPS) in the raised position. This practice
will reduce the possibility of injury or death in the
event of roll-over accident. If the Roll-Over Protective
Structure (ROPS) has been removed for any reason,
be sure to reinstall all the associated parts before
operating the tractor. NEVER alter the Roll-Over
Protective Structure (ROPS). The altered Roll-Over
Protective Structure (ROPS) may fail to provide the
designed protection. Replace the damaged Roll-
Over Protective Structure (ROPS) immediately.
Contact your local Cub Cadet Yanmar dealer for
technical assistance.
NEVER use the retractable seat belt if the foldable
Roll-Over Protective Structure (ROPS) is in the
folded position or the tractor does not have the Roll-
Over Protective Structure (ROPS).
■ Lower (Fold Down) the Roll-Over Protective Structure (ROPS)
NOTE
●The Roll-Over Protective Structure (ROPS) can be
folded down only by 90 degrees.
1. Pull out the hairpin clip from each of the insert
pins on both sides of the Roll-Over Protective
Structure (ROPS).
2. Pull out the insert pins from both sides of the Roll-
Over Protective Structure (ROPS).
(A) Hairpin clip
(B) Insert pin
2. Raise and Lower the Roll-Over Protective Structure (ROPS)
! WARNING! WARNING
3016406
(A)
3016407
(B)