26 | JetSort
®
2000 series | Setup
Date
The Date menu may be On or Off. If the date option is on, the user is prompted to enter a date
at the beginning of a new batch, after clearing DAY totals. Dates are entered on the numeric
keypad, followed by Enter. Dashes may be used between characters (MM-DD-YY). Select
SAVE/- for the dash. When Date is enabled in Setup, this is a required field.
1. Press MODE/COIN to move the cursor to the bottom menu line.
2. Press < or > to scroll forward to the desired selection: Date.
3. Press CONT to select On or Off.
ID Codes
The user ID feature is used to segment information into units. IDs can be used to identify units,
including users, products, routes or market segments. The user is prompted to enter the ID at
the beginning of a new batch or sub-batch. When ID is enabled in Setup, this is a required
field.
Batches and sub-batches can be cleared while the totals remain in memory for each ID. Up to
50 IDs can be assigned a numeric identifier, beginning with the number one (“01”).
1. Press MODE/COIN to move the cursor to the bottom menu line.
2. Press CONT to select Yes or No.
To Next Page
Loading...
