CUMMINS ALLISON JetSort 2000 - End Key Requirement

Setup | JetSort
®
2000 series | 27
End Key Requirement
Setting the End Key requirement impacts the user process for closing batches and sub-batches.
End-Key
Requirements
Description
Yes, Needed
The user is required to select End following each sub-batch. The next sub-
batch cannot begin until
End
is selected. The user selects
End
a second time
to end a batch.
Not Needed
The user is not required to select End to end a sub-batch. Sub-batches are
initiated when
Start S/Batch
is selected at the next use. The user selects
End
once to end a batch.
1. Press MODE/COIN to move the cursor to the bottom menu line.
2. Press CONT to select Yes, Needed or Not Needed.
 End Key ?
Not Needed
 End Key ?
Yes, Needed
End-Batch Display
The End Batch Display may be set to display the total batch amount or to display zero. If set to
Total Amt, the total batch or sub-batch amount displays following each coin-processing
transaction. If set to Zero, “0” displays following each batch or sub-batch.
1. Press MODE/COIN to move the cursor to the bottom menu line.
2. Press CONT to select Total Amt or Zero.
 End Bat Display
Total Amt.