CHINESE FONT Setting of the Chinese font:
Disabled
D
= Disables the use of the Chinese extended font GB18030-2000
Enabled = Enables the use of the Chinese extended font GB18030-2000
NOTE: When the Chinese font is enabled, the selection of the character code table is suspended (parameter
“CODE TABLE”). When the Chinese fonts is disabled, it returns the character code table previously in use
(parameter “CODE TABLE”).
CHARS / INCH Font selection:
A = 11 cpi, B = 15 cpi
A = 15 cpi, B = 20 cpi
D
A = 20 cpi, B = 15 cpi
NOTES:
CPI = Characters Per Inch
The parameter is printed only with CUSTOM/POS emulation enabled.
SPEED / QUALITY Setting of printing speed and printing quality:
Normal
D
High Quality
High Speed
PRINT WIDTH Width of printing area:
18 mm 34 mm 50 mm 66 mm
20 mm 36 mm 52 mm 68 mm
22 mm 38 mm 54 mm 70 mm
24 mm 40 mm 56 mm 72 mm
26 mm 42 mm 58 mm 74 mm
28 mm 44 mm 60 mm 76 mm
30 mm 46 mm 62 mm 78 mm
32 mm 48 mm 64 mm 80 mm
D
PAPER THRESHOLD Threshold value (in percent) for the recognition of the presence of paper by the paper
presence sensor:
30% 70%
40%
D
80%
50% 90%
60%
NOTCH/B.MARK
POSITION
Position of the alignment notch and choice of appropriate notch sensor:
Disabled
D
= the notch alignment is not performed
Transparent = the notch is detected by the lower sensor and the upper sensor placed
in front of (transparence)
65
To Next Page
Loading...
