and the description of device parameters see the following paragraphs.
VKP80III LAT, VKP80III REAR
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
PRINTING HEAD
STATUS
PRINTER SETTINGS
1 «••••••••» 640
----------------------------------------------------------------------------
PRINTHEAD WORKING GOOD!
PRINTER TYPE ....................................<device model>
Barcode Reader ....................................Present
LED bar RGB (hardware) ......................Present
PRINTING HEAD TYPE ........................<head model>
INTERFACE ..........................................USB
PROGRAM MEMORY TEST.................OK
DYNAMIC RAM TEST...........................OK
EXTERNAL MEMORY TEST ................OK
CUTTER TEST......................................OK
HEAD VOLTAGE [V] = 23.37
HEAD TEMPERATURE [°C] = 25
POWER ON COUNTER = 72
PAPER PRINTED [cm] = 6220
CUT COUNTER = 2218
RETRACT COUNTER = 95
COVER OPEN COUNTER = 104
Printer Emulation............................. : VKP80 III
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Hardware
Busy Condition ................................ : RxFull
USB Class ....................................... : Printer
USB Address Number ..................... : 0
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Disabled
Code Table [num] ............................ : 0
Font Type......................................... : International
Chars / inch ..................................... : A=15 B=20 cpi
Speed / Quality................................ : Normal
Paper Retracting ............................. : Disabled
Print Width....................................... : 80 mm
Paper Threshold .............................. : 40%
Black Mark Position......................... : Bottom
Black Mark Threshold...................... : 40%
Black Mark Distance [mm]............... : +00.0
PaperEnd Buffer Clear .................... : Enabled
PrintHead Test PowerOn ................. : Disabled
Data Logger..................................... : Disabled
Sleep Time [min].............................. : Disabled
Print Density.................................... : 0%
[ LF ] enter Printer setup
[ FF ] skip Setup
< device name >
SCODE: <code> - rel 1.00
DCODE: <code> - rel 1.00
FCODE: <code> - rel 1.00
KEYS FUNCTIONS
DEVICE
STATUS
PARAMETERS
FOR DEVICE
CONFIGURATION
63
To Next Page
Loading...
