VKP80III ETH
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
PRINTING HEAD
STATUS
PRINTER SETTINGS
1 «••••••••» 640
----------------------------------------------------------------------------
PRINTHEAD WORKING GOOD!
PRINTER TYPE ....................................<device model>
Barcode Reader ....................................Present
LED bar RGB (hardware) ......................Present
PRINTING HEAD TYPE ........................<head model>
INTERFACE ..........................................USB
PROGRAM MEMORY TEST.................OK
DYNAMIC RAM TEST...........................OK
EXTERNAL MEMORY TEST ................OK
CUTTER TEST......................................OK
HEAD VOLTAGE [V] = 23.37
HEAD TEMPERATURE [°C] = 25
POWER ON COUNTER = 72
PAPER PRINTED [cm] = 6220
CUT COUNTER = 2218
RETRACT COUNTER = 95
COVER OPEN COUNTER = 104
ETH. SPEED = 10 Mb/s Half-Duplex MDIX
DHCP Client .................................... : Disabled
IP Address .................................. : 10. 10. 54. 26
Subnet Mask .............................. : 255. 255. 240. 0
Default Gateway ........................ : 10. 10. 54. 254
MAC Address ............................ : 00-0E-E2-0D-5F-74
Printer Emulation............................. : VKP80 III
USB Class ....................................... : Printer
USB Address Number ..................... : 0
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Disabled
Code Table [num] ............................ : 0
Font Type......................................... : International
Chars / inch ..................................... : A=15 B=20 cpi
Speed / Quality................................ : Normal
Paper Retracting ............................. : Disabled
Paper Threshold .............................. : 40%
Black Mark Position......................... : Bottom
Black Mark Threshold...................... : 40%
Black Mark Distance [mm]............... : +00.0
PaperEnd Buffer Clear .................... : Enabled
PrintHead Test PowerOn ................. : Disabled
Data Logger..................................... : Disabled
Sleep Time [min].............................. : Disabled
Print Density.................................... : 0%
[ LF ] enter Printer setup
[ FF ] skip Setup
< device name >
SCODE: <code> - rel 1.00
DCODE: <code> - rel 1.00
FCODE: <code> - rel 1.00
KEYS FUNCTIONS
DEVICE
STATUS
PARAMETERS
FOR DEVICE
CONFIGURATION
64
To Next Page
Loading...
Need help?
General
