PAPER RETRACTING Setting of the “retract” function of the paper, with paper presence on ejector during
power-up:
Disabled
D
= “retract” function disabled
Enabled = “retract” function enabled
The parameter is printed only with VKP80II emulation enabled.
PRINT WIDTH Width of printing area:
48 mm 58 mm 68 mm 78 mm
50 mm 60 mm 70 mm 80 mm
52 mm 62 mm 72 mm
54 mm 64 mm 74 mm
56 mm 66 mm 76 mm
D
The parameter is printed only with VKP80III emulation enabled. With VKP80II emulation
PAPER THRESHOLD Threshold value (in percent) for the recognition of the presence of paper by the paper
presence sensor:
30% 70%
40%
D
80%
50% 90%
60%
PAPEREND BUFFER CLEAR Cleaning mode of the data in receive buffer, if the printing is stopped due to lack of paper:
Disabled
D
= the data remain in the receive buffer. When the paper runs out, the device
keeps the remaining data in the receive buffer and prints the remaining
portion of the ticket after that the new paper is loaded.
Enabled = when the paper runs out, all data in the receive buffer are deleted.
PRINTHEAD TEST
POWERON
Setting of the performing of the print head test:
Disabled
D
= the test is performed only during the printing of the setup report
Enabled = the test is performed at each power on
DATA LOGGER
Disabled
D
= data logger function disabled
The parameter is printed only with VKP80III emulation enabled.
74
To Next Page
Loading...
Need help?
General
