SLEEP TIME [min] Setting the inactivity period in minutes after which the device enters in sleep mode:
Disabled 10 min
1 min 15 min
2 min 20 min
3 min 25 min
4 min 30 min
5 min
D
60 min
The parameter is printed only with VKP80III emulation enabled.
PRINT DENSITY Adjusting the printing density:
-50% -12% +25%
-37% 0
D
+37%
-25% +12% +50%
NOTE:
storage to which the thermal paper has been subjected, as well as by the weight of the
same. It may therefore necessary to act on this parameter to obtain the desired print quality.
75
To Next Page
Loading...
