3. Touch the name (Mater X) to display the keyboard and enter the name of the new
material.
This parameter allows the operator to apply a permanent correction to the Bottom Dead
Centre position.
Please note that this correction is always applied and is NOT shown in the correction page. If
you experience big differences from what you expect to get, maybe check the value of this
parameter.
When activated, this function allows communication between the CybTouch and a laptop
computer, onto which Cybelec’s RFLink dongle is plugged in. This function’s default status is
off, and it is automatically reset to off every time the NC is turned on.
When activated, this function clears the index and the machine will search for them, as
it does when turning the power on, allowing the operator to re-index its machine without
turning it off.
When this parameter is set to yes, it is possible to browse the USB key from the USB
transfer screen (see USB Transfer).
This parameter allows defining the default value displayed in the Extra Bending
Parameters when activating the back-gauge retraction function.
In TouchProfile Mode, when a retraction is necessary, the numerical control will
automatically calculate and activate the function. The calculated value can naturally
be manually modified.
To Next Page
Loading...
Need help?
General
