Because the production of parts follows cycles, the programs related to those parts need to
be managed. They need to be stored, called into function, and so on.
On the CybTouch, the Program number is displayed on the top left corner of different
pages. Touching it will open the following menu:
After creating a program, an operator can save the program in order to use it again:
1. Touch the Program number (e.g. P0).
2. Touch Save program.
3. Enter the number you wish to give to the program (e.g. 1 for P1), followed by .
4. The program is now called P1 and is saved in the CybTouch.
To create a new program:
1. Touch the Program number (e.g. P1).
2. Touch New program.
3. A yellow pop-up windows asks what kind of program:
» Selecting Graphical will open a new program
in the TouchProfile Mode.
» Selecting Numerical will open a new program
in the Numerical Mode.
To Next Page
Loading...
Need help?
General
