constructor.
- In most of the configurations, it will be
sufficient to give a down command. At this
command, the axes take position, then a
second down command has to be given, in
order to move the beam.
- In other configurations, the provided start
button must be pressed.
- When the message TOL ZONE appears,
that means that a down command has been
given and that the axes are not positionned
in the current sequence. Give a start with
the provided button or on the front panel of
the DNC.
Vy
Beam bending speed.
Programmed at 0, the speed is 1 mm/s.
Programmed at 9, the speed is 10 mm/s.
(If the machine is capable of reaching this
speed)
Vy
Rising speed from BDC to PP.
Programmable from 0 (slow) to 9 (fast).
Allows to vary the speed at which the beam
rises to the PP. (Function depending on the
machine's hydraulics).
ΔT
Dwell time.
TDC
Distance from top dead center.
SP
Distance from the beam speed changing point.
(Switch Point).
F1: - F5:, Cr
Value of the auxiliary functions F1 to F5 and
crowning.
These fields can also be re-programmed by the user.
However, certain fields are related, that is modifying one provokes a
modification of the other.
CREATING A PRODUCT PAGE 11
To Next Page
Loading...
