APPENDIX E: TOOL PROGRAMMING PAGE 37
MODIFYING A PUNCH
On the PUNCH / DIE PROGRAMMING page.
Call the punch which will serve as a basis.
Place for that the cursor in the p field, introduce the desired number
and press the
key.
Modify the values as necessary.
To be able to save this punch under the same number, the former
version must first be deleted from the internal memory.
Place the cursor on the punch number and press the
key.
Leave the cursor at the same place and press
.
Caution: The die N° must not be programmed.
The former version of your punch has now been replaced by the new
one which has the same number.
DELETING A PUNCH
Call the LIST OF PUNCHES page (via the main menu).
Introduce the number of the punch to be deleted in the p/ field.
Press
.
PROGRAMMING A DIE
The programming of a die is done in the same way as for a punch, but in the
/m field.
To Next Page
Loading...
