Save this product in the internal memory by proceeding as follows:
Introduce the number you wish to give the product in the P field, in
this case the number 1 for this product which will be used later as an
example.
Press the
key.
If the system replies with the message EXISTS, choose another
number.
MODIFYING A PRODUCT
If you wish to modify a product programmed in L-alpha, call the product
from the PRODUCT L-alpha page.
Deleting a Bend
Place the cursor on the N field and enter the number of the face to be
deleted.
Press the
key; the face containing the bend is deleted.
Adding a Bend
Place the cursor on the N field and enter the number of the face in
front of which you wish to insert a new face.
Press
.The system inserts a line and copies the data of the
current bend. Modify the LENGTH and ANGLE fields.
Start the calculation by pressing
.
Continue in the next chapter. The definition of the bending order has
to be reprogrammed.
APPENDIX F: PROGRAMMING WITH L-ALPHA PAGE 45
To Next Page
Loading...
