Cybex FT 360 Functional Trainer Owner’s Manual
Maintenance
Page 7-2
Daily Procedures
Guidelines for cleaning front panel:
• Use clean soft cloths or sponges for application of cleaners and again for washing and
rinsing.
• Follow up the application with warm water rinse.
• Don’t use abrasives or high alkaline cleaners.
• Don’t leave cleaners on for long periods, wash immediately.
• Don’t apply cleaners in direct sunlight or at elevated temperatures.
• Don’t use scrapers, squeegees or razors.
• Don’t clean with gasoline.
Please Review Carefully
When using strong cleaning agents such as rubbing alcohol or bleach, it is advisable to first
test in an inconspicuous area. Other cleaning agents may contain harsh or unknown solvents
and are subject to formula changes by the product manufacturer without notice. Should you
desire to use other cleaning agents, carefully try them in an inconspicuous area to determine
potential damage to the material. Never use harsh solvents or cleaners which are intended for
industrial applications. To clean stained or soiled areas, a soft white cloth is recommended.
Avoid use of paper towels.
Cleaning products may be harmful/irritating to your skin, eyes, etc. Use protective gloves and
eye protection. Do not inhale or swallow any cleaning product. Protect surrounding
area/clothing from exposure. Use in a well ventilated area. Follow all product manufacturer’s
warnings. Cybex and its vendors cannot be held responsible for damage or injuries resulting
from the use or misuse of cleaning products.
1. Frames - Wipe down frame using a mild solution of warm water and car wash soap. Be
sure to dry thoroughly. AVOID acid or chlorine based cleaners and also cleaners
containing abrasives as these could scratch or damage the equipment.
2. Chrome - Clean chrome tubes, first using chrome polish and then using a car wax seal.
Neutral cleaners with a pH between 5.5 and 8.5 are recommended. Be sure to dry
thoroughly. AVOID acid or chlorine based cleaners and also cleaners containing abrasives
as these could scratch or damage the equipment.
3. Front Panel - The following techniques for cleaning the FT 360 front pane are based on
standard industry practice. To ensure acceptability of results, always test a sample of the
material with the cleaner and technique to be used.
To Next Page
Loading...
Need help?
General
