Cybex FT 360 Functional Trainer Owner’s Manual
Technical
Specifications
Page 2-1
2 - Technical Specifications
General Specifications
Frame Finish
• Shall be made of mechanical quality 11 gauge and 16 gauge steel purchased in mill run
quantities to assure the best consistency.
• Prior to applying finish, each part shall be put through a multi-stage wash to remove all
oils and to chemically prepare the surface for maximum adhesion. After the wash, the
frames shall be dried and coated with an Electrostatically applied powdercoat finish that
shall be applied in powder form and then baked until cured.
• The finish shall be textured and very hard, assuring a scratch and chip resistant finish.
Weight Selection
• Weights are to be selected by using a high quality selector pin that completely penetrates
the weight plate and locks in place to eliminate any chance of disengaging during use.
The pin shall be attached to the weightstack with a plastic lanyard in order that the pin
stays with the appropriate machine.
Weight Stacks Configuration
• All weight stacks shall have 4” x 18” x 1”, 20 pound weights.
Weight Plates
• Shall be made of solid cold-rolled steel with wrinkle black powder coat finish.
• Guide rod holes shall be machined to a tolerance of .006 inches.
Top Weight Plate Bushings
• Low-friction bushings shall surround the guide rods for smooth gliding motion.
To Next Page
Loading...
Need help?
General
