Cybex FT 360 Functional Trainer Owner’s Manual
Technical
Specifications
Page 2-2
Pulleys
• Shall use Dupont Corp. fiberglass-reinforced nylon 70G33 material, tensile strength rated
at 22,500 PSI with 6203ZZ double sealed bearings dynamic load rated at 1600 lbs.
• Pulleys shall be 4.50 inches in diameter with a cable groove with a depth of .250 inches.
Swivel Pulley
• Shall be molded from glass reinforced nylon, with a tensile breaking strength of at
least 14,000 PSI.
Weight Transport
• Shall be lubricated, 7 x 19, 1/8” galvanized steel, nylon coated aircraft cable with
breaking strength rated at 2000 pounds.
• All cable ends shall be finished off with a swaged fitting with a breaking strength
equal to the cable itself.
Weight Stack Guide Rods
• Shall be solid ground and polished cold-drawn steel with minimum yield strength of
100,000 PSI with a hard chrome plated piston steel finish with an overall minimum
accuracy of .010.
Weight Stack Suspension
• Shall have heavy-duty neoprene bumpers with an 80-durometer rating under the weight
stacks to reduce shock and vibration stresses to the frame and facility.
Frame Construction
• Primarily 1 1/2 x 2” tubing with 11 gauge wall thickness, but different tubing sizes and
wall thickness shall be used as required through engineering stress analysis.
• Shielding shall be 16 gauge wall thickness sheet metal.
• Fully welded frames for maximum structural integrity and minimum maintenance.
• All machining and welding will be done utilizing jigs and fixtures to insure highest
quality and interchangabiliity of parts.
Pivot Adjustment
• Shall be cast from 1020 steel and black powder coated.
Clevis
• Shall be cast from 1020 steel and black powder coated.
To Next Page
Loading...
Need help?
General
