Working from a CLI
AlterPath BladeManager Manual 5-9
Enter Primary Ethernet Subnet Mask: 255.255.255.0
Secondary Ethernet IP address: (S)tatic, (N)one or
(K)eep current ? [K]:
Subinterface eth0:1 IP address: (S)tatic, (N)one or
(K)eep current ? [K]:
Subinterface eth0:9999 IP address: (S)tatic, (N)one or
(K)eep current ? [K]:
Configure more Ethernet Subinterfaces: (Y)es, (N)o or
(L)ist ? [N]: l
eth0:9999, 199.199.199.199, 255.255.255.252
Number of Subinterfaces already configured: 1
Configure more Ethernet Subinterfaces: (Y)es, (N)o or (
L)ist ? [N]: y
Enter the Ethernet number [0-1]: 0
Enter the Subinterface index [0-9999]: 1
Subinterface eth0:1 IP address: (S)tatic or (N)one ? [S]:
Enter Subinterface eth0:1 IP address: 1.1.1.1
Enter Subinterface eth0:1 Subnet Mask: 255.0.0.0
Configure more Ethernet Subinterfaces: (Y)es, (N)o or
(L)ist ? [N]:
VLAN eth0.2 IP address: (S)tatic, (N)one or
(K)eep current ? [K]:
Configure more Ethernet VLANs: (Y)es, (N)o or
(L)ist ? [N]: l
eth0.2, 2.2.2.2, 255.255.0.0
Number of VLANs already configured: 1
Configure more Ethernet VLANs: (Y)es, (N)o or (L)ist ? [N]:
Enter Ethernet Default Gateway [none]:
*** Configuration changed!
*** Execute saveconf to save the new values in flash.
Do you want to make these changes effective now (y/n)? y
This script creates the configuration file /etc/network/ifcfg-eth<index>,
which has the same format as ifcfg-eth0 and ifcfg-eth1.
OBS: In this example, index = 0, 0:1, 0:9999 and 0.2
The third option, (K)eep command, gives you the option to skip to the next
Ethernet interface without changing the configuration of the current interface.
To Next Page
Loading...
