FX3 Programmers Manual, Doc. # 001-64707 Rev. *C 179
FX3 Development Tools
14.The project settings are over. Click on “Ok” and build the project. The project should build cor-
rectly.
12.2.3 Attaching Debugger to a Running Process
The debugger can be attached to an already running process. This is required when the executable
has been downloaded to the FX3 by means other than JTAG (USB/I2C/SPI boot). The following
steps describe the procedure to attach to a running process:
1. Start the GDB server. Note that the “Init regs on start” must Not be checked. If this is checked:
a. Un-check it
b. Close the GDB server
c. Reset/restart the FX3
To Next Page
Loading...