Cyrus Pre2 DAC - Ferrite Clamp; Connecting to the AC Mains Supply

Cyrus Pre
2
DAC User Instrucons
10
Ferrite clamp
There are two power cables in the accessory carton. Once
you have selected the power cable suitable for your market,
you can enhance the performance of your Cyrus product
by ng the supplied lter. This device is simple to t and
helps to remove undesirable ‘noise’ present in all domesc
mains supplies.
The hinged lter simply folds around the cable and will
lock together once you rmly close the shaped channels
around the cable. You should t the lter at the end of the
cable as shown. Allow a 20mm length of wire between
the plug moulding and the lter. This will ensure opmum
performance and allow good cable exibility.
20mm
Connecng to the AC Mains Supply
Connect the socket on the AC Power cable to the Power
inlet 1* on the rear panel of the amplier. Now connect the
cable to a suitable AC power point.
NOTE: The means to disconnect this product from the
mains supply is the mains plug. Ensure that the mains plug
is accessible at all mes.