Cyrus Pre2 DAC - Checking Programmed Commands; Problems with Learning; Sending TV or SAT Commands

Cyrus Pre
2
DAC User Instrucons
22
Checking programmed commands
• Select the mode that you just programmed and check
that the commands were learned successfully.
NOTE: The TV or SAT mode key should ash red when
sending a command. If the mode key is not ashing, then
the command has not learned correctly.
• Make a note of any commands that have not programmed
correctly and repeat the learning process to add these
in.
NOTE: When you start the learning process it does not erase
any programmed keys so you can re-program individual keys
if required.
Problems with learning
If none of the commands have learned correctly, try re-
starng the learning process again. Test a few keys rst
to ensure that your handset is compable for learning. If
the test works then connue to program the rest of the
commands you need.
If you sll have problems, check carefully that the mode
light is ashing correctly as you send a command to learn.
If not, it may be that the baeries need replacement in the
reference handset or that the spacing between the handsets
is not ideal. Try adjusng the spacing between the handsets
and repeang the learning process.
If you connue to have problems, it may be that your
handset is incompable with the learning process. This
could happen with an older design of handset or one that
has an unusual code-set.
Sending TV or SAT commands
Once you have programmed all the keys with the commands
you want, you can use the remote control to send commands
to your TV or Satellite receiver etc.
• Press the TV or SAT key to select the mode you want.
• Press the command key.
The mode key will ash red when sending a programmed
command.