FENCE OVERVIEW
Tips on Using Fence Mode
Ÿ Read Fence Training Manual before using Fence mode.
Ÿ Always test your Fence settings before use (see pg. 47).
Ÿ The handheld unit and collar unit(s) must acquire a GPS Signal before
using Fence mode (see pg. 29). If a GPS signal is not acquired, turn
unit OFF and back ON.
Ÿ Do not set up a Fence where satellite signals may be obstructed or
interrupted. GPS coordinates can be inaccurate. For the best results,
avoid marking the center of the fence and boundary points close to
buildings, trees, overhead obstructions, or anything that can cause
electromagnetic interference. These interferences can cause
miscalculations in GPS coordinates. Be sure to test the center point
and boundary points after fence settings have been saved (see pg. 47).
Ÿ Lost GPS Signal Alert - An "X" will appear on the bottom left corner of
the handheld unit when the collar unit’s GPS signal is lost. The GPS
signal icons will also turn red.
Ÿ The handheld unit and collar unit(s) must have Radio communication
between each other in order for features to work properly.
Ÿ Find proper intensity level for each dog before use (see pg. 33).
Ÿ Keep handheld unit flat for accurate compass readings.
Ÿ All training functions are available in the Fence mode.
Ÿ Use the Left directional key to quickly switch between Fence View and
Training View.
WARNING - Always Deactivate Fence when not in use.
To Next Page
Loading...