COMPASS CALIBRATION
The D.E. Systems handheld unit utilizes a high performance electronic
compass chip in order to get accurate fence and tracking data. This
compass must be calibrated by the user. The compass should be the
first time it is used, after storage periods, after new batteries are installed,
and after long distance changes on the handheld’s last known location.
For best results, calibrate the compass each time the handheld unit
is powered on.
Always calibrate the compass outdoors and away from magnetic fields
such as metals, cell phones, cars, buildings, electricity sources, trees,
etc.
Calibrating the compass requires rotating the handheld unit along three
different axes, the X, Y, and Z axes.
NOTE - Hold handheld unit horizontal and parallel to the ground with the
screen facing the sky.
To Calibrate Compass:
1. Begin the Calibration process by pressing Menu→Setup→
Compass Calibration, and the follow the directions on screen.
2. Hold unit horizontally and parallel to the ground so that the screen is
facing the sky.
To Next Page
Loading...