ACTIVATING / DEACTIVATING FENCE
To Activate Fence:
1. Press MENU→ Fence→ ENTER
2. Highlight Activate and press ENTER
3. The Fence is now active and the Fence View Screen will be shown
(see fig. in next page).
To Deactivate Fence:
1. Press MENU→ Fence→ ENTER
2. Highlight Deactivate and press ENTER
3. The Fence is now deactivated and the Training Screen will be shown.
WARNING - Deactivate Fence when not in use.
NOTE - GPS coordinates can be inaccurate +/- 10 yards. Both Fence
Center and Fence Zones can have inaccuracies. It is important to create
visible cues for your dog and fully test the boundaries.
Creating a visible fence:
1. Activate Fence.
2. Holding the collar unit at your dog’s neck level, walk towards the
warning zone and place a flag or marker at the point where the collar
unit gives its warning.
3. Walk back into the safe zone and repeat step 3 until a visible
boundary is established. The distance between flags will vary on the
size of the fence. 10 ft. intervals are suggested.
CREATING VISIBLE FENCE
To Next Page
Loading...