6. Choose NEXT to move on to Stimulation Zone settings.
7. Choose the distance from the Center Point to the beginning of the
Stimulation Zone. This will be the Warning Zone.
a) Press ENTER in the highlighted Stim Zone Starts @ box to
change the distance.
b) Using the navigation keys, enter the desired number and press
OK when finished.
8. Choose the Stimulation Level for the Stimulation Zone.
a) Press ENTER in the highlighted Stim Option box to change the
Stimulation Level.
b) Using the navigation keys, enter the desired number and press
OK when finished. Enter ‘0’ if no stimulation is desired.
9. Choose NEXT to continue to Stimulation Zone End settings.
a) Press ENTER in the highlighted Stim Zone Ends @ box change
the distance.
b) Using the navigation keys, enter the desired number and press
OK when finished.
11. Choose NEXT to save the new Fence settings. After settings are
saved, the Fence Menu screen will be shown.
To Edit Current Fence Settings With the Same Fence Center:
1. MENU→Fence→EditSettings→Enter
2. Follow steps 4-11 in “Setting Up Fence Boundaries”.
NOTE - Only one Fence setting can be saved at a time. Changing the
Fence settings will delete the previously saved Fence settings.
SETTING UP FENCE BOUNDARIES
To Next Page
Loading...