DAP-1325 N300 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Using WPS Function without Web-based Interface
You can use the WPS function without accessing the web-based interface of the extender. To do
this, you need to configure the following extender's settings:
1. Specify relevant security settings for the wireless network of the extender.
2. Move the WPS Enable switch to the right.
3. Save the settings and close the web-based interface (click the SAVE button in the
notification and then click the Logout line of the menu).
Later you will be able to add wireless devices to the WLAN by pressing the WPS button of the
extender.
1. Select the PBC method in the software of the wireless device that you want to connect to the
extender's WLAN.
2. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
3. Press the WPS button of the extender and release. The POWER/WPS LED will start
blinking.
Page 61 of 92
To Next Page
Loading...
