DAP-1325 N300 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Client
On the Wi-Fi / Client page, you can configure the extender as a client to connect to a wireless
access point.
Figure 53. The page for configuring the client mode.
To configure the extender as a client, move the Enable switch to the right. Upon that the following
fields are displayed on the page:
Parameter Description
Broadcast wireless
network 2.4 GHz
If the switch is moved to the left, devices cannot connect to the
extender's WLAN. Upon that the extender can connect to another
access point as a wireless client.
Connecting to network A method for connecting to another access point.
Page 65 of 92
To Next Page
Loading...
