D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
The following fields are available on the page:
Parameter Description
Bandwidth
The channel bandwidth for 802.11n standard in the 2.4GHz band.
20 MHz: 802.11n clients operate at 20MHz channels.
20/40 MHz: 802.11n clients operate at 20MHz or 40MHz channels.
Autonegotiation
20/40 (Coexistence)
Move the switch to the right to let the access point to automatically
choose the most suitable channel bandwidth (20MHz or 40MHz) for
the connected devices (this setting can substantially lower the data
transfer rate of your wireless network). The switch is displayed when
the 20/40 MHz value is selected from the Bandwidth drop-down
list.
TX power The transmit power (in percentage terms) of the access point.
B/G protection
The 802.11b and 802.11g protection function is used to minimize
collisions between devices of your wireless network.
Select a value from the drop-down list.
Auto: The protection function is enabled and disabled automatically
depending on the state of the network (this value is recommended if
your wireless local area network consists of both 802.11b and
802.11g devices).
Always On: The protection function is always enabled (this setting
can substantially lower the efficiency of your wireless network).
Always Off: The protection function is always disabled.
Short GI
Guard interval (in nanoseconds). This parameter defines the interval
between symbols transmitted when the access point is
communicating to wireless devices.
Enable: the access point uses the 400 ns short guard interval. Only
for the wireless network operating modes which support 802.11n
standard (see the value of the Wireless mode drop-down list on
the Wi-Fi / Basic Settings page).
Disable: the access point uses the 800 ns standard guard interval.
Drop multicast
Move the switch to the right to disable multicasting for the access
point's WLAN. Move the switch to the left to enable multicasting
from the WAN connection selected on the Advanced / IGMP page.
Adaptivity mode
Move the switch to the right to prevent your wireless network from
interfering with radars and other mobile or stationary radio systems.
Such a setting can slow down the access point's WLAN.
Page 103 of 158