DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Using WPS Function without Web-based Interface
You can use the WPS function without accessing the web-based interface of the access point. To do
this, you need to configure the following access point's settings:
1. Specify relevant security settings for the wireless network of the access point.
2. Click the ENABLE WPS button.
3. Save the settings and close the web-based interface (click the Logout line of the menu).
Later you will be able to add wireless devices to the WLAN by pressing the WPS button of the
access point.
1. Select the PBC method in the software of the wireless device that you want to connect to the
access point's WLAN.
2. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
3. Press the WPS button of the access point, hold it for 2 seconds, and release. The WPS LED
will start blinking.
Page 91 of 158
To Next Page
Loading...
