D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
System Time
On the System / System Time page, you can manually set the time and date of the access point
or configure automatic synchronization of the system time with a time server on the Internet.
Figure 120. The System / System Time page.
To set the system time manually, follow the next steps:
1. Move the Enable NTP switch to the left.
2. In the Time Settings section, specify needed values. To specify the time set up your PC or
portable device, click the SET LOCAL TIME button.
3. Click the APPLY button. The System date and System time fields will be filled in
automatically.
To enable automatic synchronization with a time server, follow the next steps:
1. Move the Enable NTP switch to the right.
2. Specify the needed NTP server or leave the value specified by default in the NTP Servers
section. If you need to specify several servers, click the ADD SERVER button.
3. Select your time zone from the Change time zone drop-down list in the NTP Settings
section. To set the time zone in accordance with the settings of your operating system or
portable device, click the DETERMINE TIMEZONE button.
4. Click the APPLY button. The System date and System time fields will be filled in
automatically.
To enable automatic adjustment for daylight saving time of the access point, move the Daylight
saving time switch to the right in the NTP Settings section and click the APPLY button.
Page 153 of 158