D-Link DAP-1360U

DAP-1360U Wireless N300 Access Point & Router
User Manual
Configuring via Web-based Interface
Firmware Update
On the System / Firmware Update page, you can update the firmware of the access point and
configure the automatic check for updates of the access point's firmware.
!
Update the firmware only when the access point is connected to your PC via a wired
connection.
Figure 112. The System / Firmware Update page.
The current version of the access point's firmware is displayed in the Current firmware version
field.
By default, the automatic check for the access point's firmware updates is enabled. If a firmware
update is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the right and click the APPLY SETTINGS button.
By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified.
You can update the firmware of the access point locally (from the hard drive of your PC) or
remotely (from the update server).
Page 143 of 158